Enjo

[*Ang*]

So I have just started my collection of Enjo and used the mop this morning for the first time. It was certainly nice and easy but the question I have is this - how wet does the floor fibre have to be?

I forgot to wet it first so was just spraying the fibre constantly during the mopping process and it felt like I was doing this evey few seconds! Should I have completely wet the fibre first or is spraying it with water the way to go?

TIA

[Becs_bubs]

I usually wet it first before I put it on the mop head - just do a quick run under cold water, if you know what I mean? Not saturate it, but not a sprinkle, either. Then loosely roll it up inwards just to remove the excess water so you're not dripping everywhere. I find that's generally enough to do the job!

[Party-of-five]

I dunk mine in the sink before and then squeeze it out...I leave it quiet wet if the floors are pretty dirty like today but if just a quick going over I just dampen it.

[*Ang*]

Thanks ladies, so that must have been my mistake, not wetting it first!

Also I used their wood cleaner and I actually found that the floors have turned out quite streaky.Is there a trick to using that as well?