Is this normal for Itti bitti snaps?

[BekZ]

Hello,

I have been using Itti Bitti snap ins (not sure if this is the correct terminology) since September. I am finding that the button/snap bits are coming away from the insert. Now I have no ability to snap the insert in and a big hole in the insert.

Any one else had this happen?

[StrawberryMumma]

That's not good! Never happened to us. Maybe email IB? They have a 6 month warranty but maybe that's up now if you got them in Sept?

What a pain!

[Arimeh]

Yup that was the start of my shredding problem.

I've just sold all my itti bitti shells cos it just kept on happening to us. You could see if they would replace it, but you might just be up for the cost of replacing them yourself. Wait until they have a 2 for one special or something - at least its not so exxy then.

[CrystalBoo]

With all my snaps, I'm really careful to hold both sides close to the snap when opening, instead of just ripping them open by holding the fabric.
I've had mine about the same time and they have no signs of wear that I can see (touch wood)
It's hard to convince DH to take the same care though... lol

[BekZ]

Arimeh - One of mine has started to shredd too.

Crystal - I have been fairly careful with them too.

Even the little red button in the middle of the booster has come out in two of the them.

[Arimeh]

Crystal - I sorta pluck mine open with my fingernail - so its definitely not a case of user error here